PDA

View Full Version : Intake/exhaust manifolds and Cylinder heads


  1. Powder coated intake and Shelby Valve cover
  2. Advice...
  3. valve springs.
  4. Head porting = voodoo.
  5. I'll let alitte info go
  6. New Intakes coming from FWD Perf
  7. Torqu specs?
  8. anyone run faze gauges?
  9. 16 valve motor
  10. Blow-by
  11. Different Cams
  12. 88 TBI Cam
  13. efi header for l body
  14. How to Install a Cam
  15. Cam centerline
  16. cam bore
  17. Air induction
  18. 88 tbi cam
  19. BOV Blues
  20. need info on hot air to intercooled 2.2L
  21. Cold Air/Ram air intake
  22. Factory Cams: slider vs. roller
  23. "reverse head install"
  24. headgasket
  25. Need some advise.. Having a head BUILT
  26. Antifreeze smell/smoking on start up?
  27. MP vs. Fidanza cam sprocket
  28. Roller cam on 86 Head
  29. Does this sound right? Vacuum block on '87 CSX
  30. headgasket
  31. pressure relief valves?
  32. check out my 3" side exit
  33. 88 cam and Fidanza gear
  34. G head compatibility
  35. damn ex. studs
  36. 3.3L springs and retainers
  37. best cam for running 25psi
  38. Five valves per cylinder
  39. intercooler
  40. Old Article on Conquest IC Install in an 88 CSX-T
  41. 2.5 cam choices?
  42. Head Gasket Blown?
  43. Cam identification
  44. Intercooler angle
  45. what do you think?
  46. G head
  47. sandblasting head
  48. hey
  49. Is this normal?
  50. Shaving throttle body
  51. External wastegate?
  52. intake
  53. How would this work for a revised PCV system?
  54. Adjustable Cam Sprocket
  55. Porting...
  56. Anyone have head casting #'s???
  57. Are these MP pieces?
  58. Measuring cam lift
  59. Rocker arm ratio
  60. roller cam followers
  61. Setting a Cam But,,,,,
  62. getting head back tomorrow
  63. Self Porting
  64. Head bolt pattern and torque specs
  65. Compression and torque
  66. F'ed up head, anyone ever see this?
  67. How do you remove these GD valves?
  68. Cam Walked Out Of Head....
  69. Cam Cap Torque Specs.
  70. New felpro gasket. Looks like they beefed them up
  71. P&P questions (pics availible)
  72. head bolts
  73. Hope this is right...
  74. fuel pressure regulation
  75. cylinder head
  76. Will this work
  77. Help on porting my head
  78. intake
  79. Intercoolers
  80. PT lifter alternative??
  81. 8V and 16V head flow #s
  82. intake manifold
  83. Intake Plumbing
  84. Charge Air Temp sensor
  85. Vacuum Lines
  86. cam question
  87. need an exhaust Manifold ASAP
  88. J&C cylinder heads on Ebay
  89. Swirl vs G-head valves
  90. Who here runs a big valve head?
  91. Why do our cylinder heads suck?
  92. I have a couple cylinder heads....
  93. Crank Case Evacuation